Table of Contents
Advertisement
Allows you to select a device to boot immediately. Press <Enter> on the device you select and select Yes
HDD/USB/FDD
If your system becomes unstable and you have loaded the BIOS default settings, you can use this function
File in HDD/USB/FDD
automatically created by the BIOS, such as reverting the BIOS settings to the last settings that worked
Chapter 3
Appendix
Before you begin
Motherboard driver disk.
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. Then connect the power connector from your power supply to the hard drive.
refer to Chapter 2, "BIOS Setup," "Peripherals."
Steps:
1.
Ensure OnChip SATA Channel is enabled under Peripherals. Set
2.
settings and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
This mode supports Windows 8 64-bit installation only.
\BootDrv\UEFI RAID Utility folder in your motherboard driver
- 30 -
Select File in
Select
to RAID.
Advertisement
Table of Contents
