Step-By-Step Installation Guide; Step 1. Placement Of The Mounting Plate - Samsung ME11A7510 Series Installation Manual

Step-by-step installation guide

Step 1. Placement of the mounting plate

A. Removing the microwave oven from the carton/Removing the mounting plate
Styrofoam
Mounting Plate
Screws
Install_ME11A7510DS_AA_DE68-04709A-00_EN+MES.indb 9 Install_ME11A7510DS_AA_DE68-04709A-00_EN+MES.indb 9
1. Remove the installation
Carton
instructions, Exhaust
Adaptor, filters, glass tray,
and the small hardware
bag. Do not remove the
Styrofoam protecting the
front of the oven.
2. Fold back all 4 carton flaps
fully against carton sides.
Then carefully roll the oven
and carton over onto the
top side. The oven should be
resting in the Styrofoam.
Screws
3. Pull the carton up and off
the oven.
4. Remove and properly
discard plastic bags.
5. Remove the 2 screws from
the mounting plate. This
plate will be used as the
rear wall template and for
mounting.
NOTE
Retain the two screws. You will
need to re-insert the screws in
their original locations after you
have removed the mounting
plate.
B. Finding the wall studs
Wall Studs
Center
THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD.
1. Find the studs using one of the
following methods:
A. With a stud finder – a magnetic
device which locates nails.
OR
B. Use a hammer to tap lightly
across the mounting surface until
you hear a solid sound. This will
indicate a stud location.
2. After locating the stud(s), locate the
stud's center by probing the wall
with a small nail to find the edges of
the stud. Then, place a mark halfway
between the edges. The center of
any adjacent studs should be 16˝ or
24˝ from this mark.
3. Draw a line down the center of the
studs.
English 9
2021-06-16 2021-06-16 10:55:28 10:55:28