Dcdc Board, Standby Board, Gnd Bracket Board - Sony STR-DN840 Service Manual

2-6.

DCDC BOARD, STANDBY BOARD, GND BRACKET BOARD

‡ :LUH VHWWLQJ
DCDC board
rear side
Note: Process so that lead wire
does not contact with
STANDBY board
power cord.
(except US, CND)
qs bracket,
DCDC (N104)
qj four screws
(+BVTP 3 u 8)
qk STANDBY board
0 two screws (+BVTP 3 × 8)
(US, CND)
four screws (+BVTP 3 × 8)
(except US, CND)
(except US, CND)
(AEP, UK, AUS)
qf Cut the cable tie
‡ :LUH VHWWLQJ
(US, CND)
rear side
Note: Process so that lead wire does not
DCDC board
contact with power transformer.
‡ :LUH VHWWLQJ
(US, CND)
rear side
(US, CND)
H
qs bracket, DCDC
H
I I
(except US, CND)
2 clamp, sleeve ferrite
qa two screws
(+BVTP 3 u 8)
(except US, CND)
9 clamp,
sleeve ferrite
7 CN901
(2P)
8 cushion (R)
H
qh CN951 (2P)
qg CN953 (3P)
(except US, CND)
rear side
clamp,
sleeve ferrite
(except US, CND)
rear side
cushion (R)
DIGITAL board clamp, sleeve ferrite
G
3 cushion (R)
5 Wire is removed
from the pin, lead.
qd DCDC board
qa two screws
(+BVTP 3 u 8)
1 one screw
(+BVTT 4 u 8 (S))
G
6 CN941 (4P)
DCDC board
Note: Process so that lead wire does not
cushion (R)
contact with power transformer.
STR-DN840
cushion (R)
cable tie
DIGITAL
board
4 GND BRACKET
board
• Abbreviation
AUS : Australian model
CND : Canadian model
11