Lcd Resolution - IBM Low Power 667Mhz Panel PC PPC-1510PT User Manual

Plug and Play Aware O/S
Set this option to Yes to inform AMIBIOS that the operating system can handle plug and Play (PnP) devices. The settings
are No or Yes. The Optimal and Fail-Safe default settings are No.
Display Device
Select the display device for system. The available options are CRT Only, CRT + LCD.

LCD Resolution

Select the display resolution for LCD panel. The available options are 640x480, 800x600, 1024x768.
PCI Latency Timer (PCI Clocks)
This option specifies the latency timings (in PCI clocks) for PCI devices installed in the PCI expansion slots. The
settings are 32, 64, 96, 128, 160, 192, 224, or 248.
IRQ3/4/5/7/9/10/11/14/15 Assigned to
These options specify the bus that the specified IRQ line is used on. These options allow you to reserve IRQs for legacy
ISA adapter cards. These options determine if AMIBIOS should remove an IRQ from the pool of available IRQs passed
to devices that are configurable by the system BIOS. The available IRQ pool is determined by reading the ESCD
NVRAM. If more IRQs must be removed from the pool, the end user can use these options to reserve the IRQ by
assigning an ISA/EISA setting to it. Onboard I/O is configured by AMIBIOS. All IRQs used by onboard I/O are configured
as PCI/PnP . IRQ12 only appears if the Mouse Support option in Advanced Setup is set to Disabled. IRQ14 and 15 will
not be available if the onboard PCI IDE is enabled. If all IRQs are set to ISA/EISA and IRQ14 and 15 are allocated to the
onboard PCI IDE, IRQ9 will still be available for PCI and PnP devices, because at least one IRQ must be available for
PCI and PnP devices. The settings are ISA/EISA or PCI/PnP . The Optimal and Fail-Safe default settings are PCI/PnP .
DMA0/1/3/5/6/7 Assigned to
DMA Channel 6
DMA Channel 7
IRQ3
IRQ4
IRQ5
IRQ7
IRQ9
IRQ10
IRQ11
IRQ14
IRQ15
PnP
PnP
ISA/EISA
SA/EISA
PCI/PnP
ISA/EISA
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
- 32 -