Husqvarna 115 145727 Operator And Parts Manual page 9

6
UPPER CHUTE INSTALLATION
NOTE: Depending on model, it may be necessary to
drill a ¼" hole to move the upper chute latch nut.
1. Slide upper chute onto lower chute, lining up
notches and channels. If latch on lower chute and
latch nut on upper chute are aligned, skip to Step
3.
2. If upper chute latch nut is not aligned to the lower
chute bungee, drill a ¼" hole 2½" from the lower
edge of the upper chute and in alignment with the
lower chute latch. Move latch nut and hardware to
new hole placement.
3. Stretch bungee latch up onto acorn nut on upper
chute to secure.
Before continuing to Step 7, locate the seal
fastening kit (packed separately) and install the
top cover grommet.
10
ASSEMBLY
Drill hole placement,
if necessary
7
CHUTE / HOOD INSTALLATION
1. Push upper chute through the gasketed opening
in the cover assembly.
2. Rotate chute so the chute opening is downwards
toward the container bags.
Hood Inlet
8
LEVELING MOWER DECK
Be sure deck is properly leveled for best mower
performance. See your mower operator's manual for
instructions.
Rotate upper chute to point
downwards towards bags