Return Hose (Control Valve To Fluid Cooler) - Mercury MerCruiser Service Manual

2. Install the return hose onto the power‑assisted steering pump reservoir and secure it with hose clamps.
a
3. Install the return hose onto the fluid cooler and secure it with hose clamps.
4. Fill and bleed the system. Refer to Filling and Bleeding.

Return Hose (Control Valve to Fluid Cooler)

Removal
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
NOTE: Use a suitable container to catch the fluid that drains from the pump and hoses.
1. Note the position and routing of the return hose before removal.
2. Loosen the hose clamp and remove the return hose from the fluid cooler.
90-8M0099748 eng DECEMBER 2015
Power-Assisted Steering Pump and Related Components
a - Return hose
56934
a
NOTICE
a
© 2016 Mercury Marine
a - Return hose
56933
a - Return hose and hose clamp
56935
Page 8A-21