Emptying Dirty Water Tank - Hoover E1 Owner's Manual

carpet cleaninG

eMptYinG dirtY water tank

Your Carpet Cleaner is equipped with a shut off valve within your dirty water tank. When the dirty water tank
becomes full, the blue float (viewed from top of tank) will rise, shutting off the air flow through the nozzle.
To reduce the risk of injury from moving parts- unplug before servicing
2.10 Grasp top of dirty water
tank handle and push latch to
release.
2.11 Grasp handle and pull tank
out of base.
2.12 Remove dirty water tank
lid.
2.13 To empty dirty water tank,
grasp handle with one hand and
nozzle with the other and empty
into sink. Replace dirty water
tank lid.
2.14 Rinse dirty water tank and
filter with hot tap water. Wipe
and let dry thoroughly before
storing to prevent mildew from
forming.
(continued)
• For best cleaning results use a steady, forward and backward
motion. Cleaning should be done at half the speed of dry
vacuuming. For heavily soiled areas, repeat if necessary.
• While depressing solution spray trigger, slowly push unit
forward. Release trigger and pull unit backward in the same path
to remove dirty water and solution from carpet. (For heavily soiled
areas, repeat if necessary).
• IMPORTANT: IF THE SOUND OF THE MOTOR CHANGES TO
A HIGH PITCH, THIS INDICATES THE DIRTY WATER TANK IS
FULL AND MUST BE EMPTIED.
WARNING
2.10
2.12
2.14
• IMPORTANT •
2.11
2.13
• IMPORTANT •
9
Do not use any chemicals
when cleaning the tank.