Installation (Installation To The Basic Unit) - Toshiba nv Series Instruction Manual

Chapter 2 Installation and wiring

2.1 Installation (installation to the basic unit)

8
6F8C1358
Before installing or removing the module,
WARNING
make sure that the basic unit to which the EN8
module is installed is turned off.
Otherwise, it may cause an electric shock.
Do not touch the interior of the product except
WARNING
the switches.
It may cause an electric shock.
Install it under an environment that satisfies
CAUTION
the product specifications.
When installing it under an environment that
does not satisfy the product operating
temperature range, apply forced cooling with
cooling equipment.
Operating temperature range: 0 to 55°C
Before installation or wiring, remove the static
CAUTION
electricity from your body.
The static electricity accumulated in the
human body may cause failure of the product.
When installing the product to the basic unit,
CAUTION
do not bend the pins of the station bus
connector.
If it is difficult to insert the module to the basic
CAUTION
unit, remove it once and try again rather than
forcing it.
When installing two or more Ethernet modules
CAUTION
to the same basic unit, make sure that the
system and segment of the transmission path
are correct.
Use a Phillips screwdriver.
CAUTION
To prevent damage to the screws, use a
screwdriver that is suitable for the screws.
Mandatory
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited
Prohibited