Harbor Freight Tools 94515 Assembly Instructions Manual

Harbor freight tools 4' x 6' greenhouse with two vents assembly instructions

Advertisement

Quick Links

4' x 6' GREENHOUSE
WitH tWO VENtS
Model
94515
ASSEMbly iNStRUctiONS
Visit our website at: http://www.harborfreight.com
tO pREVENt SERiOUS iNjURy, REAd ANd UNdERStANd
All WARNiNGS ANd iNStRUctiONS bEfORE USE.
All rights reserved. No portion of this
©
®
Copyright
2006 by Harbor Freight Tools
.
manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools. Diagrams
within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described
herein. Tools required for assembly and service may not be included.
for technical questions or replacement parts, please call 1-800-444-3353.
Revised Manual 10h

Advertisement

Table of Contents
loading

Summary of Contents for Harbor Freight Tools 94515

  • Page 1 2006 by Harbor Freight Tools manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein.
  • Page 2: Table Of Contents

    If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. for technical questions, please call 1-800-444-3353. SKU 94515 contents UNpAcKiNG...
  • Page 3: Specifications

    If there is any doubt, do not attempt to assemble this product. USE EyE pROtEctiON. assembling this product. ANSI-approved safety impact eye goggles are available from Harbor Freight Tools. dO NOt OVERREAcH. tripping, falling, back injury, etcetera. StAy AlERt.
  • Page 4 Replace or repair damaged or worn parts immediately. REplAcEMENt pARtS ANd AccESSORiES: replacement parts. Only use accessories intended for use with this product. Ap- proved accessories are available from Harbor Freight Tools. MAiNtAiN tHiS pROdUct WitH cARE. better performance. MAiNtENANcE: For your safety, service and maintenance should be performed regularly by a qualified technician.
  • Page 5: Base Assembly

    (not provided). The gravel should reach up to about below the lip of the base. for technical questions, please call 1-800-444-3353. SKU 94515 bASE ASSEMbly ” deep. The floor of the hole must be level and square. The base Assembly ”...
  • Page 6: Frame Assembly

    Bolt (43), then 2) secure it using a Nut (52). Use two Hold Down Connectors for each Cor- ner Stud. for technical questions, please call 1-800-444-3353. SKU 94515 fRAME ASSEMbly Front Floor Plate (17) outside...
  • Page 7 Rear Brace should face inward. Attach each end to the upper hole on the Corner Bracket (13). (See figure A.) for technical questions, please call 1-800-444-3353. SKU 94515 figure A inside top of each Corner inside of the two Corner...
  • Page 8: Assembling The Roof Frame

    Corner Brackets (13). (See figure b.) Secure each corner in place with the Crown Beams on the outside of the Corner Brackets. for technical questions, please call 1-800-444-3353. SKU 94515 Assembling the Roof frame figure b Page 8...
  • Page 9: Assembling The Studs And Braces

    (43) in the center of the Side Stud (10). Attach the other Side Diagonal Brace (22) to the other side in the same manner as the first. for technical questions, please call 1-800-444-3353. SKU 94515 figure c outside of the frame with...
  • Page 10 Place the Gutter End Caps (48) onto the ends of the Side Ceiling Plates (36) oriented with a gap in the bottom to allow water to drain out of the gutters. for technical questions, please call 1-800-444-3353. SKU 94515 left doorway...
  • Page 11: Assembling The Roof Studs And Braces

    Repeat for the Right Window Support Beam (15b) on the right side. At this time, verify that the Door Rail (14) is oriented correctly, with the rounded edge facing up – see number 3 on page 7. for technical questions, please call 1-800-444-3353. SKU 94515 figure d REV 07a Page 11...
  • Page 12: Assembling The Windows

    Attach a Right Door Frame (28) to the other side of the Center Door Frames (26) in the same way. for technical questions, please call 1-800-444-3353. SKU 94515 Assembling the Windows Assembling the door down.
  • Page 13 Door Rail (14) to prevent the door from sliding off the rail. Attach the Right and Left Rail End Caps (49,50) onto the ends of the Door Rail. for technical questions, please call 1-800-444-3353. SKU 94515 pANE Side view...
  • Page 14: Installing The Transparent Panels

    Swing the center portion of the Clip up against the panel. Two edges of the Clip swing under the edge of the panel and the center edge holds the panel in place. for technical questions, please call 1-800-444-3353. SKU 94515 15a/15b Page 14...
  • Page 15: Panel Installation Diagram

    1-800-444-3353. SKU 94515 panel installation diagram # = panel clip (67) location Page 15...
  • Page 16: Inspection, Maintenance, And Cleaning

    ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF RE- PLACEMENT PARTS THERETO. for technical questions, please call 1-800-444-3353. SKU 94515 inspect the general condition of the Greenhouse. Check for Page 16...
  • Page 17: Parts List

    Left Window 2’ 1” Support Beam Right Window 2’ 1” Support Beam Rear Floor Plate Front Floor Plate Window Stop for technical questions, please call 1-800-444-3353. SKU 94515 pARtS liSt Q’ty pARt 4’ 4’ 2’ 6’ 6’ dEScRiptiON Door Slide 1’...
  • Page 18 Window Brace Door Roller Peak Cap Note: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. for technical questions, please call 1-800-444-3353. SKU 94515 pARtS liSt (continued) Q’ty pARt Hold-down Connector...

Table of Contents