Table of Contents
Advertisement
WARNING! TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL
OPERATION:
Do not install a female quick
coupler on the tool. Such a coupler
contains an air valve that allows air
tool to retain pressure and operate
accidentally after the air supply is
disconnected. The Foot Pedal is
(included). Also verify air source can
dedicate 7 CFM @ 110-120 PSI.
Note: Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
3.
The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
4.
Make sure throttle or switch is in the
off position; refer to Operation section
for description of controls.
5.
Close the in-line safety valve between
the compressor and the tool.
6.
Turn on compressor according to the
manufacturer's directions and allow it
to build up pressure until it cycles off.
7.
Adjust the air compressor's output
regulator so that the air output is
enough to properly power the tool,
but the output will not exceed the
tool's maximum air pressure at any
time. Adjust the pressure gradually,
while checking the air output gauge
to set the right pressure range.
8.
Inspect the air connections for leaks.
Repair any leaks found.
9.
If the tool will not be used at this
time, turn off and detach the air
supply, safely discharge any
Item 58047
For technical questions, please call 1-888-866-5797.
residual air pressure, and release
the throttle and/or turn the switch to
its off position to prevent accidental
operation.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set Up
FROM ACCIDENTAL
OPERATION:
Turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and press down on
the Release Bar (43) before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT
SERIOUS INJURY
Page 7
Advertisement
Table of Contents
