GE 234D1050P001 Owner's Manual page 14

Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Outer Door
Inner Door
Beauty Buttons
Tapping
Screws
Partially
Inserted
Screw
Tighten All
Screws
14
Reassemble Door Assembly
IMPORTANT: Make sure there is no dirt or any other foreign material in between the
window panes .
11. Place the plastic outer door onto the inner door . Make sure that the handle part of
the outer door is opposite the hinge as shown .
12. Turn the door over and fasten the outer door to the inner door using the 6 tapping
screws .
Move Strike Bracket
13. Using a putty knife or any other flat tool, remove the 3 beauty buttons located on the
dryer where the door will be installed and install them on the opposite side .
14. Switch the strike bracket and its cover to the opposite side by removing the screws .
Reinstall both on the opposite side .
Reinstall Door Assembly
15. The door is now ready to be installed on the dryer . To ease this step,
the hinge has keyholes that allow a partially fastened screw to be used
as a hook .
Partially fasten a screw to the uppermost screw hole . Hook the door on the partially
fastened screw .
Fasten the hinge by installing the other 2 screws and tightening the partially
fastened screw above .