Turning Power On/Off; Turning On The Main Power - Sharp PN-HS551 Operation Manual

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

Turning on the main power

Main power switch
Off mode, when main power is off.
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning Power On/Off

Turning power on/off
Press the POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
Status
Green lit
Orange lit
Green flashing
* Standby mode when POWER SAVE MODE is set to ON.
Networked standby mode when POWER SAVE MODE is set
to OFF. Networked standby mode allows the monitor to be
turned on via network (LAN, RS-232C, and HDMI CEC).
TIPS
• When the main power switch is off, the monitor cannot be
turned on.
• If the monitor is in the input signal waiting state and you
press the POWER button or MONITOR OFF button, the
monitor enters standby state.
• Setting the SCHEDULE flashes the power LED alternately
in red and orange in standby state.
[Rear view] [Front view]
POWER button
Power LED
Status of the monitor
Power on
Power off (Standby state*)
Input signal waiting state
15
E