Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Garmin GMR 24 HD
Summary of Contents for Garmin GMR 24 HD
- Page 1 GMR 18/24 GMR 18 HD/24 HD radome installation instructions...
- Page 2 Information in this document is subject to change without notice. Garmin reserves the right to change or improve its products and to make changes in the content without obligation to notify any person or organization of such changes or improvements. Visit the Garmin Web site (www.garmin.com) for current updates and supplemental information concerning the use and operation of this and other Garmin products.
-
Page 3: Product Registration
In Europe, contact Garmin (Europe) Ltd. at +44 (0) 870.8501241 (outside the UK) or 0808 2380000 (within the UK). Note: The Garmin radome has no user-serviceable parts. If you encounter a problem with your unit, please take it to an authorized Garmin NMEA dealer or contact Garmin Product Support for repairs. -
Page 4: Installation
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. When drilling or cutting, always check first to see what is on the other side of the surface. If you experience difficulty with the installation, contact Garmin Product Support or seek the assistance of a professional installer. -
Page 5: Installation Procedures
1. When a suitable mounting location is determined, verify that the mounting hole locations are aligned fore and aft, and use the included mounting template or reference Figure 1 to drill four 9.5 mm ( Garmin compatible or Raymarine mount.) ®... -
Page 6: Cable Runs
When installing the power and network cables, observe the following: • It is not recommended to cut the RJ-45 marine network cable, but the Garmin radome package includes a field install kit if it is necessary to do so. Make sure you save the end you cut. It is important that the wires are connected to the new RJ-45 connector the same way. -
Page 7: Front Of Boat Offset
Note: When using the Garmin radome with an expanded network, each network component must be installed according to its installation instructions. This diagram only shows how a Garmin radome communicates with an expanded network, and does not show the full wiring needs of the other network components. -
Page 8: Specifications
Wind Velocity: Wind speed up to 100 Kts Antenna RPMs: 24 or 30 rpm Minimum Range: 20 meters (65 feet) Range Discrimination: 20 meters (65 feet) RF Transmit Frequency: 9410 ± 30 MHz ") H ") H Garmin Radome Installation Instructions... - Page 9 Toward Bow GMR 18/18 HD 201.5 mm ") GMR 24/24 HD 277.4 mm (10 / ") Garmin Radome Installation Instructions GMR 18/18 HD 457.0 mm (18") GMR 24/24 HD 610 mm (24") GMR 18/18 HD 114.0 mm 141.5 mm ") GMR 24/24 HD 190.8 mm...
-
Page 10: Fcc Compliance
This Notice is provided in accordance with California’s Proposition 65. See WarNING: Do not cut the fuse holder from the red wire. The fuse holder must remain in place for the Garmin radome to function correctly. fuse holder may damage your boat's circuitry. -
Page 11: Software License Agreement
PRODUCT. Some states do not allow the exclusion of incidental or consequential damages, so the above limitations may not apply to you. Garmin retains the exclusive right to repair or replace the unit or software or offer a full refund of the purchase price at its sole discretion. - Page 12 For the latest free software updates (excluding map data) throughout the life of your Garmin products, visit the Garmin Web site at www.garmin.com. © 2010 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151 Street, Olathe, Kansas 66062, USA Garmin (Europe) Ltd.