Sharper Image WS0832 User Manual page 5

Close the battery cover. Make sure the gasket (around the battery compartment) is
properly seated in its place prior to closing the door. Tighten the set screw.
Note: Do not install the batteries backwards. You can permanently damage the sensors.
The solar panel does not charge the batteries, so rechargeable batteries are not needed or
recommended.
Note: We recommend installing Lithium AA batteries for sensors.
The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds
thereafter. Each time it flashes, the sensor is transmitting data.
Place the battery cover and push it to close the compartment.
Note: If the sensor does not power up after inserting the batteries, press the reset button
shown in Figure 6.
Figure 5
5