Panasonic PT-VZ570 Service Manual page 70

SECTION 3 ADJUSTMENTS
1. 3. 4. Restore the data (after board replacing)
1. Set the projector to "Normal-Standby" mode (ON(G)/STANDBY(R) indicator is lighting in red).
2. Start up the software "ServiceVZ570.exe" with a PC.
3. Select language and click the [OK] button.
4. 1) Choose the available serial port number on your PC.
2) Choose a model number.
3) Click the [Data] button.
5. 1) Click the [Transmission] button of Micom data.
2) Select the saved data file and click the [ Open(O) ] button.
3) When the progress bar reaches the right-side end, the transmission of data is completion.
4) Restore the Gamma data in the same procedure of 1-3.
5) Restore the Uniformity data in the same procedure of 1-3.
j
6. After completing the writing, disconnect the AC code and connect it to turn on again and then check the color uniformity
and gamma characteristic of the projector.
j
k
l
ADJ-7
k