Table of Contents
Advertisement
[ Removing the DVD Deck ]
Before removing Pick Up PCB and DVD PCB connector, short circuit the position shown in Fig. 1 using
a soldering iron. If you remove the DVD Deck with no soldering, the Laser may be damaged.
[ Installing the DVD Deck ]
Remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD
PCB connector.
NOTE
•
Before your operation, please read "PREPARATION OF SERVICING".
•
Use the Lead Free solder.
•
Manual soldering conditions
• Soldering temperature: 350 ± 5˚C
• Soldering time: Within 2 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
•
When Soldering/Removing of solder, use the draw in equipment over the Pick Up Unit to prevent the
Flux smoke from it.
WHEN REPLACING DVD DECK
Fig. 1
A1-2
Pick Up PCB
Short circuit using a
soldering iron.
Advertisement
Table of Contents
