Honda GX100 Owner's Manual page 9

37ZDD6020.fm 9 ページ ２０１９年１１月１９日 火曜日 午前９時３分
4. Install the oil filler cap/dipstick and tighten securely.
OIL FILLER CAP/DIPSTICK
OIL FILLER HOLE
(bottom edge)
SEALING WASHER
(Replace)
OIL DRAIN PLUG
Wash your hands with soap and water after handling used oil.
AIR CLEANER
A dirty air cleaner will restrict air flow to the carburetor, reducing engine
performance. If you operate the engine in very dusty areas, clean the air
filter more often than specified in the MAINTENANCE SCHEDULE.
Operating the engine without an air filter element, or with a damaged air
filter element, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the Distributor's Limited Warranty.
Inspection
Remove the two screws and the air cleaner cover. Inspect the air filter
elements. Clean or replace dirty air filter elements. Always replace
damaged air filter elements.
Refer to page 9 for instructions that apply to the air cleaner and filter
service.
Reinstall the air filter elements and air cleaner cover.
PAPER AIR FILTER ELEMENT
FOAM AIR FILTER ELEMENT
SCREWS
AIR CLEANER CASE
Cleaning
1. Remove two screws from the air cleaner cover, and remove the cover.
2. Remove the foam air filter element from the cover.
3. Remove the paper air filter element from the air cleaner case.
PAPER AIR FILTER ELEMENT
FOAM AIR FILTER ELEMENT
SCREWS
AIR CLEANER COVER
4. Inspect both air filter elements, and replace them if they are
damaged. Always replace the paper air filter element at the
scheduled interval (see page 7).
5. Clean the air filter elements if they are to be reused.
Paper air filter element: Tap the paper air filter element several times
on a hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
from the air cleaner case side. Never try to brush off dirt; brushing will
force dirt into the fibers. Replace the paper air filter element if it is
excessively dirty.
Foam air filter element: Clean in warm soapy water, rinse, and allow
to dry thoroughly. Or clean in non-flammable solvent and allow to
dry. Do not put oil on the foam air filter element.
Clean Squeeze and dry
Do not twist.
6. Wipe dirt from the inside of the air cleaner case and cover using a
moist rag. Be careful to prevent dirt from entering the air duct that
leads to the carburetor.
7. Place the foam air filter element to the air cleaner cover, then reinstall
the paper air filter element and cover to the air cleaner case.
8. Install the air cleaner cover, and tighten the two screws securely.
ENGLISH
AIR CLEANER CASE
2
, 30 psi)] through the filter element
Dip in oil Squeeze
Do not twist.
9