Setup - JVC GR-VF10EG Service Manual

1. Torque driver
Be sure to use to fastening the mechanism and exte-
rior parts because those parts must strictly be control-
led for tightening torque.
2. Bit
This bit is slightly longer than those set in conventional
torque drivers.
3. Tweezers
To be used for removing and installing parts and wires.
4. Chip IC replacement jig
To be used for adjustment of the camera system.
5. Jig connector cable
Connected to CN105 of the main board and used for
electrical adjustment, etc.
6. Communication cable
Connect the Communication cable between the PC
cable and Jig connector cable when performing a PC
adjustment.
7. PC cable
To be used to connect the VideoMovie and a personal
computer with each other when a personal computer
is used for adjustment.
8. Service support system
To be used for adjustment with a personal computer.

3.2 SETUP

1. Setup for electrical adjustment with personal computer.
NOTE: Remove one screw (1) first and the cover (JIG)
next.
COMMUNICATION CABLE JIG CONNECTOR
to CN105-8 pin
RED
( JLIP_RX )
to CN105-17 pin
WHITE ( JLIP_TX )
to CN105-7 pin
BLACK
( GND )
CN105
Cover(JIG)
COMMUNICATION CABLE
3-2
9.
10. INF adjustment lens
11. INF adjustment lens holder
12. Camera stand
13. Light box assembly
14. Gray scale chart (for Light box assembly)
15. Color bar chart (for Light box assembly)
Jig connector cable
1
Fig. 3-2-1 Connection for Service support system
Alignment tape
To be used for check and adjustment of interchange-
ability of the mechanism.
To be used for adjustment of the camera system.
To be used together with the camera stand for operat-
ing the VideoMovie in the stripped-down
condition such as the status without the exterior parts
or for using commodities that are not yet conformable
to the interchangeable ring.
To be used together with the INF adjustment lens
holder.
To be used for adjustment of the camera system.
To be used for adjustment of the camera system.
To be used for adjustment of the camera system.
RS232C
COM Port
PC CABLE
Service Support System
MENU
Personal Computer