Table of Contents
Advertisement
(on the rear panel)
LINE OUT
R
L
R + L
/
AUX IN (input level 0.5 Vrms, 6 kΩ)
Other instruments such as a sound generator can be con-
nected to this terminal, and the sound will be output from
this instrument's speakers. To receive monaural sound,
connect the other instrument to the R/R+L terminal. (Do not
connect the L terminal.)
LINE OUT (output level 1.5 Vrms, 600 Ω)
By connecting an external high-power amplifier, the sound
can be reproduced at a high volume. To output monaural
sound, connect the external equipment to the R/R+L terminal.
(Do not connect the L terminal.)
MIDI
These terminals are for connection to another MIDI instru-
ment.
(beneath the left end of keyboard)
MIC
MAX
VOLUME
MIN
PHONES
PHONES × 2
Headphones can be connected to this instrument.
• When headphones are plugged into this jack, the spea-
kers of this instrument are disabled.
MIC (PR703/PR903)
A microphone can be connected to this instrument and
the sound output through the speakers. Use the VOLUME
control to adjust the volume.
• Effects such as reverb can be applied to the microphone
input.
AUX IN
R
L
R + L
/
(PR703/PR903/PR1000)
THRU
OUT
MIDI
COMPUTER
By connecting this terminal to the serial port of a computer,
performance data can be exchanged. Use the switch to select
the type of computer.
• Be sure that the power to this instrument is turned off when
connecting to a computer or when changing the switch
setting.
Caution:
Failure to turn off the power before changing the switch
setting may result in malfunction.
• When no computer is connected, or when a MIDI interface
is used, the switch should be set to MIDI.
Connection to a Macintosh series computer
Use an ACCESSORY CABLE (SZ-JJAP1: sold separately)
to connect the COMPUTER terminal of this instrument to the
modem port or printer port of a Macintosh Series computer.
Set the switch to MAC.
• Set the MIDI interface clock of the Macintosh software to
1 MHz.
• Do not remove the core at either end of the cable.
Connection to a PC
Use an ACCESSORY CABLE (SZ-JJAT1: sold separately)
to connect the COMPUTER terminal of this instrument to the
RS232C terminal of a PC. Set the switch to PC2.
• The MIDI driver included with the cable should be installed
in the computer. (Refer to the manual accompanying the
cable.) This MIDI driver is not compatible with Windows NT
or Windows 2000.
• Do not remove the core at either end of the cable.
* All product and company names are trademarks or registe-
red trademarks of thier respective owners.
COMPUTER PEDAL IN
IN
PC2
PC1
MIDI
MAC
Advertisement
Table of Contents
