Removal/Installation; Stator Inspection - Honda GXE2.0H Manual

dummyhead dummyhead
POWER UNIT
ROTOR SHAFT REMOVAL/INSTALLATION
TOOL FITTING
Install the following and place the assembly on wooden blocks [1].
– [2] Dowel pin (2)
– [3] Tool: Rotor guide (070PG-8A00100)

REMOVAL/INSTALLATION

Push the rotor guide [1] down without wooden blocks to release the rotor
shaft [2].
To install, insert the rotor shaft into the rotor guide while holding it securely
set with wooden blocks [3].

STATOR INSPECTION

Remove the PDU cover (page 5-2).
Disconnect the PDU 3P (Gray) connector [1].
Check for connector for loose contacts or corroded terminals.
Measure the coil resistance between the terminals of the stator side 3P
(Gray) connector.
CONNECTION: Red – White
Blue – Red
White – Blue
STANDARD: 65.5 – 72.5 mΩ (20°C/68°F)
Measure the insulation resistance between each connector terminal and the
motor housing and rotor shaft (with 1,000 VDC range in a insulation
resistance tester).
RESISTANCE: 10 MΩ or more
Replace the stator assembly if the coil resistance is out of specification, or if
the insulation resistance is abnormal.
7-8
[2]
[3]
[3]
[1]
[1]
[2]
[3]
[1]
Blue White Red