Advertisement
Installation, cont'd
Final adjustments
1.
2.
Figure 7 — Adjust speaker and lock in place
N
3.
N
V-Lock
5
™
Turn on the audio source and any associated devices.
Adjust the source and device settings as desired to get the
optimum audio output for your speaker application.
To adjust the speaker angle insert the allen hex tool into
the locking access, loosen the hex cap screw, and adjust to
the desired angle (see figure 7). Tighten the hex cap screw
down about 6 to 8 turns clockwise, until snug, for the
speaker to sit securely in the desired position.
After locking it into place, check that the speaker
is secure and cannot be lifted from the wall mount
assembly. If it does lift out, continue tightening the hex
cap screw until it is no longer possible to lift the speaker
from the assembly.
Replace the Extron logo, pressing it firmly into place.
For speaker details, specifications, troubleshooting tips,
and service access information refer to the
SI 3 User's Guide supplied with the speakers, or online
at www.extron.com
Wall Mount Assembly Kit • Installation
Turn clockwise
to tighten.
Advertisement
