D WALT one of the most reliable partners for professional power tool users. Technical Data DWE625, DWE627 DWE625 DWE625 DWE627 Plunge Router Voltage WALT declares that these products described under Technical Type Data are in compliance with: 2006/42/EC, EN62841‑1:2015 + AC:2015;...
Failure to follow all instructions listed below PLUNGE ROUTER may result in electric shock, fire and/or serious injury. DWE625, DWE627 SAVE ALL WARNINGS AND INSTRUCTIONS WALT declares that these products described under “technical data” are in compliance with: FOR FUTURE REFERENCE...
Page 9
English b ) Use personal protective equipment. Always wear eye g ) Use the power tool, accessories and tool bits etc. protection. Protective equipment such as a dust mask, in accordance with these instructions, taking into account the working conditions and the work to be non‑skid safety shoes, hard hat or hearing protection used performed.
WALT tool is double insulated in accordance with EN62841; therefore no earth wire is required. The following pictograms are shown on the tool: The DWE625 LX (115V) is intended to be used with a safety Read instruction manual before use. transformer manufactured to BSEN61558 and BS4343. Never work without this transformer in place.
Intended Use WARNING: Do not change the turret stop while the The DWE625 and DWE627 routers have been designed for router is running. This will place your hands too near the professional heavy duty routing of wood, wood based materials cutter head.
Page 12
English Installing and Removing a Cutter (Fig. C, F) 6. Adjust the depth of cut using the quick height adjuster 16 and the corresponding graduation. The adjusted depth of WARNING: Do not tighten the collet without a cut is indicated by the pointer 17 ...
English Connecting Dust Extraction Adaptor (Fig. K) head into the workpiece. CAUTION: The dust extraction adaptor consists of a main section 32 • Excessive cutting may cause overload of the motor cover 33 , an extraction tube adaptor 34 , one extraction tube or difficulty in controlling the tool, the depth of screw ...
English On/Off Trigger Switch (Fig. A) WARNING: Always follow the bit manufacturer’s speed recommendations as some bit designs require specific WARNING: To reduce the risk of serious personal speeds for safety or performance. injury, turn unit off and disconnect it from power If you are unsure of the proper speed or are experiencing any source before making any adjustments or removing/ type of problem, contact the bit manufacturer.
English Using a Side Fence (Fig. M) 6. Rotate the quick height adjuster 16 until the depth stop bar 12 touches multiple turret stop 13 . Secure in position CAUTION: Ensure working position is comfortable and at by tightening the quick height adjuster lock 15 ...
English Table Mode (Fig. Q) 1. Remove the cap nut 51 and the thumb wheel 4 replace it with the height adjusting tool (DE6966) available (DWE627 ONLY) as an option. WARNING: Before DWE627 is installed into the 2. Screw the threaded end of the height adjusting tool to the router table, check that the router table meets all height stop rod ...
English Optional Accessories WARNING: Since accessories, other than those offered by D WALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only D WALT recommended accessories should be used with this product.
Page 20
Belgique et WALT ‑ Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be luxembourg België en luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)