Table of Contents
Advertisement
Important! Do not turn on and operate both linked transmitters at any time. Turn off both transmitters before beginning.
1.
Press the group button to select a group. The receiver automatically scans the selected group to find the best available
channel.
2.
Turn on transmitter 1 and link it to the receiver. Adjust the gain, and then turn off the transmitter.
3.
Turn on transmitter 2 and press and hold the link button to link it to the receiver. Adjust the gain, and then turn off the
transmitter.
Identifying Linked Transmitters and Receivers with Remote ID
Use the remote ID feature to identify linked transmitter and receiver pairs in multiple receiver systems.
To activate remote ID:
1.
Momentarily press the link button on the transmitter or receiver.
2.
The screen of the linked receiver will blink and display ID, while the status LED on the linked transmitter will flash red/
green.
3.
To exit remote ID mode, momentarily press the link button or allow the function to timeout.
Gain Adjustment
Use the gain buttons on the receiver to increase or decrease the gain of a linked transmitter:
•
Turn on the linked transmitter and momentarily press the gain buttons to adjust the gain in 1 dB increments
•
For faster gain adjustments, press and hold the gain buttons
Tip: Monitor the audio and observe the receiver audio meter level while adjusting the gain to prevent signal overload.
Shure Incorporated
5/11
Advertisement
Table of Contents
