Preparation For Use - Emerson EWV401M Owner's Manual

For some of the most common types of connections, please refer to the diagram below. Use only one connection.
For any further complex connections, please contact your local dealer. (You may need additional accessories which
are not supplied).
1
Disconnect the antenna or cable from your TV.
3
Connect one end of the coaxial cable (supplied) to
the ANT.OUT (Bottom jack) of your VCR.
Basic Connections
Audio "Y" cable (not supplied)
Video cable (not supplied)
IN
IN
L R
AUDIO VIDEO
TV A/V Terminal
USING OPTIONAL AUDIO/VIDEO
OUTPUT JACKS
If your TV has A/V input jacks, you may connect your
VCR's AUDIO/VIDEO OUTPUT jacks to the
audio/video input jacks on back of your TV.
Direct audio/video connections usually result in a better
picture and sound quality for tape playback. Please see
your TV's owner's manual for A/V input connections.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building, as close to the point of cable entry as practical.
H7836

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS
ANT
IN
AUDIO
OUT IN
OUT
CH3 CH4
VIDEO
Back of the VCR
2
Connect the antenna or cable to the ANT.IN (Top jack)
of your VCR.
4
Connect the other end of the coaxial cable (supplied)
to the UHF/VHF antenna jack of your TV.
Coaxial Cable
(Supplied)
OR
VHF
VHF
UHF
UHF
TV Antenna Terminal
USING AUDIO/VIDEO INPUT JACKS
You can use the A/V input jacks on the front or the back
of the VCR.
1) When you connect the external source to input jacks
on the back of the VCR, select "L1" position for re-
cording by pressing the 0, 0, 1 on the remote control
or CHANNEL Up/Down button.
2) When you connect the external source to input jacks
on the front of the VCR, select "L2" position for re-
cording by pressing the 0, 0, 2 on the remote control
or CHANNEL Up/Down button.
Note: "L1" or "L2" is found before the lowest memo-
rized channel. (Example: CH2)
- 6 -
[Cable Box or Satellite Box]
OU T
IN
From
Cable or
Satellite
Company
OR
Indoor or
Outdoor
Antenna
OR
From
Cable Company
(No Cable Box)
ANT in
EN
0J01