Jacuzzi Nova Pure Air Installation - Use - Maintenance page 26

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12
Troubleshooting...
The blower does not turn on
- Check that the main power supply switch for the tub is on.
- Press down on the button for a few seconds and then release it.
- Insufficient water level (when attempting to activate the function,
the light flashes).
Fill the tub with the required amount of water (once it has reached
the level sensor position, the light turns off or, if it was on when the
fault occurred, it stops flashing); press the button again to turn the
blower on.
The blower stops on its own
- Check whether there was a power blackout.
- The hydromassage is factory-set to last approximately 30 minutes,
after which the cycle stops on its own.  
- Should the water level fall below the minimum for whatever rea-
son, the blower stops and the light starts flashing: fill the tub with
the required amount of water (once it has reached the level sensor
position, the light turns off or, if it was on when the fault occurred,
it stops flashing); if desired, add more water and press the button
again to turn the blower on.
NOTE: Do not press the button while the light is flashing, otherwise the
function is stopped and the blower circuit is drained (see the relevant
chapter).
Maintenance
ATTENTION! Before carrying out any maintenance opera-
tion, disconnect the appliance from the power supply line.
Cleaning the air vents (blower)
- Use a large-head screwdriver to prise the nozzle out of its slot
(pressurised), taking care not to scratch the bottom of the tub.
- Remove all of the nozzles and clean them using a mild detergent,
removing any limescale, soap residue etc.
- Check that the holes are free from any build-up and refit the clean
nozzles.
- To remove any water from the blower circuit pipes, see "Draining
the blower circuit".
Cleaning the tub
It is simply sufficient to dry the various components; use only mild,
non abrasive liquid soap for cleaning the tub.
Do not use scouring pads, detergent powders, acetone or other
solvents.
Extraordinary maintenance
Jacuzzi Europe S.p.A. recommends to contact your local Jacuz-
zi® Service Centre for all operations and interventions not de-
scribed in this manual.
26

Advertisement

Table of Contents
loading

Table of Contents