Echo SHC-210 Operator's Manual page 20

20
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: 4 mm Hex wrench, screwdriver, clean rag, small
brush
Parts required: ECHO
Lithium Based Grease
WARNING
Blades are very sharp. Wear gloves to protect hands, otherwise
serious personal injury may result.
1. Loosen gear housing assembly locating screw (A) and mounting
screws (C). Remove the gear box from the drive shaft housing.
2. Pull the drive shaft (B) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful not to
get dirt on the flex shaft.
4. Install the gear housing assembly.
TM
LUBE 14 oz. cartridge P/N 91015 or
®
DANGER