Out Of Range; No Remote Output; Car Select - Directed Electronics VIPER 3203 User Manual

Directed electronics automobile alarm user manual

Table of Contents

Out of Range

Each time a command is performed the Responder LE will expect a

command conﬁrmation from the system. If a command conﬁrmation

is not received the

plays as an alert.

Occasionally when a command is performed the remote may not

generate a command conﬁrmation output or out of range output. This

indicates that the system received the command but it was an incom-

plete command (e.g. aux button pressed too short to activate the trunk

release) or it was an illegal message (e.g. the command was cor-

rupted due to local RF interference). These are temporary normal func-

tions of the system and remote, perform the command again within 10

seconds to return to normal operation.

Car 2 must ﬁrst be turned on (See Remote Control Conﬁguration sec-

tion to turn on).

Press

and hold the

the transmit LED and beeps once or twice to indicate the selected

car is 1 or 2.

Release

LED and beeps continue to perform car select. Once the car is

selected a command can be performed by pressing one of the

command buttons.

Note: The 1-way remote does not emit any indication beeps. The

transmit LED ﬂashes once or twice to indicate car one or car two.

and transmit LED's ﬂash and a long fault tone

button, then press and release while the transmit

the

button for 3 seconds. The remote ﬂashes

Table of Contents

Show Quick Links

Table of Contents