Lamp - Dell 1209S User Manual

LAMP

Using the Lamp menu, you can adjust the display settings of your projectors. The
Picture menu, provides the following options:
L H —Displays the operating hours since the last lamp timer reset.
AMP OUR
P S —Select Yes to set the Power Saving delay period. The delay period is
OWER AVING
the time you want the projector to wait without an input signal. By default, the
delay period is set to 120 minutes. However, you can set this to 5, 15, 30, 45, 60, or
120 minutes.
If an input signal is not detected during the delay period, the projector turns off
the lamp and goes into power saving mode. If an input signal is detected within
the delay period, the projector automatically turns on. If an input signal is not
detected within two hours, the projector switches from Power Saving mode to
Power Off mode. To turn on the projector press the Power button.
E M —Select On to use the projector at a lower power level (165 Watts),
CO ODE
which may provide longer lamp life, quieter operation, and dimmer luminance
output on the screen. Select Off to operate at normal power level (200 Watts).
L R —After you install a new lamp, select Yes to reset the lamp timer.
AMP ESET
Q S —Select Yes to turn off the projector with a single press of the
UICK HUTDOWN
Power button. This function allows the projector to quick power off with an
accelerated fan speed. Slightly higher acoustic noise is expected during quick
power off.
Using Your Projector 29