Advertisement
FMR-DACT-KEYPAD | Operation Instructions | 7.0
Figure 6:
Additional Functions of the [Drill], [Disable], and [Reset] Keys
1 - Press [Drill] to move the cursor to the next position
2 - Press [Disable] to move the cursor back one position
3 - Press [Reset] to clear the character that is currently selected
7.0
Programming the FPT-DACT with the FMR-DACT-KEYPAD
Only use the FMR-DACT-KEYPAD to program and debug.
1. Program the DS9602, D9068, and FPT-DACT according to the D9068 (P/N: 45386), DS9602 (P/N: 45387), or
FPT-DACT Operation and Installation Guide (P/N: F01U002505).
2. If there is no FMR-DACT-KEYPAD activity for 3 min, it disables. The FMR-DACT-KEYPAD buzzer sounds
and a System Fault message appears.
3. Disconnect the FMR-DACT-KEYPAD from the DACT as described in the D9068 (P/N: 45386), DS9602
(P/N: 45387), or FPT-DACT Operation and Installation Guide (P/N: F01U002505).
8.0 Troubleshooting
Table 1: Troubleshooting
FMR-DACT-KEYPAD Status
The sounder is heard
continuously and a System
Fault message appears.
The FMR-DACT-KEYPAD
does not respond to input.
Three-beep error tone sounds
at all FMR-DACT-KEYPADs.
6
PHN NMBR 1: 5551
1
234????????????
PHN NMBR 1: 5551
2
234????????????
PHN NMBR 1: 5551
3
234????????????
Cause
•
The yellow and green ground wires are disconnected.
•
The FMR-DACT-KEYPAD was not correctly
programmed at the DACT.
•
The DACT malfunctioned.
The address is not set.
An incorrect key was pressed.
Programming the FPT-DACT with the FMR-DACT-KEYPAD
PHN NMBR 1: 5551
Drill
234????????????
PHN NMBR 1: 5551
Disable
234????????????
PHN NMBR 1: 5?51
Reset
234????????????
Bosch Security Systems, Inc. | 8/06 | F01U002307C
Corrective Action
Replace the DS9602,
D9068, or FPT-DACT.
Set the address.
Press the correct key.
Advertisement
