Table of Contents
Advertisement
3.
Reinsert tray back into the
device.
Figure 5
4.
Connect the adapter to the power input
on the DNH-200, then plug the adapter
into a nearby power outlet.
5.
Use an Ethernet cable to connect a
DNH-200 and a switch or router that
the management computer is connected.
6.
Manage the device from a computer.
Enter https://DNH-200-XXXX.local* in
the address field of your browser.
*Where XXXX are the last four digits or letters of your
device's MAC ID. You can find the MAC ID printed on
the label at the bottom of your device.
7.
Log into the device's administration
interface. The default username is
"admin" and password is "admin".
8.
Configure the device via its web
interface after login successful.
Connecting through a Console Connection
Use a console cable to connect to the divice's
console port. This cable is a RS-232 serial to
RJ-45 connector cable designed to use with
this device. A terminal emulation program is
required to connect to the console port on
the device.
4
Figure 6
1.
Connect the RS-232 serial interface to the
serial port of the management PC.
2.
Connect the RJ-45 interface to the console
port of the device.
3.
Open a terminal emulation program on
the management PC and configure the
properties of the connection as follows:
• The speed (baud): 115200 bps
• The data bits: 8
• The parity: None
• The stop bits: 1
• The flow control should be None.
4.
Connect to the device and the Limited
Command Line Interface (CLI) should be
available.
Installation
Mounting on a Solid Wall or Ceiling
The DNH-200 can be mounted on a solid wall
or in an EIA standard size 19-inch rack, which can
be placed in wiring closet with other equipment.
You can either hang the unit on the wall by using
the wall mount keyholes on the rear of the unit
or by using the supplied mounting bracket.
The following procedure explains how to use
the keyholes.
1.
Use the wall mount template to mark the
screw mounting positions on the wall.
2.
Drill the 2 supplied wall anchors into the
wall at the marked positions and screw the
2 supplied screws into them. Make sure
they stand out ~6.7mm.
DNH-200 Quick Installation Guide
Figure 7
1
Advertisement
Table of Contents
