Water Level; Bucket Operation - GE APHR50 Owner's Manual

Using the Dehumidifier
Removing Collected Water (cont)
To Install Hose: Push in hose and gently pull to make
sure it is secure. Should not be able to be removed. You
should hear a "click" that lets you know the hose is inserted
correctly.

Water Level

The dehumidifier will turn off automatically when the
bucket is full, or when the bucket is removed or not
replaced in the proper position.

Bucket Operation

DO NOT remove the foam piece and magnet block in
the bucket assembly. If removed, the Dehumidifier will
not work properly.
When the coil is defrosted, the compressor or fan will
automatically restart and dehumidifying will resume.
8
Insert
Press
Pull
To Release Hose: Press the blue button on top of the
connector attached to the dehumidifier and pull the hose out
to remove. Be sure to turn off the pump before removing the
hose.
NOTE: DO NOT kink or crimp hose, as it can block water
flow.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
49-5000628 Rev. 0