Dial And Buttons - Husqvarna QW36S114 User Manual

Table of Contents

Advertisement

14
www.husqvarna-electrolux.se

8. DIAL AND BUTTONS

8.1 Introduction
The options/functions are
not available with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set incompatible options/
functions.
8.2 On/Off
Press this button for a few seconds to
activate or deactivate the appliance. Two
different tunes sound while switching the
appliance on or off.
As the Stand-by function automatically
deactivates the appliance after several
minutes to reduce the energy
consumption, you may need to activate
the appliance again.
For more details, refer to Stand-by
paragraph in Daily Use chapter.
8.3 Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
The indicator Cold
The indicator of the set temperature
comes on.
8.4 Spin
When you set a programme, the
appliance automatically sets the
maximum spin speed allowed except
programme Denim.
Additional spin options:
• No Spin
comes on.
Set this option to deactivate all spin
phases. The appliance performs only
the draining phase of the selected
= cold water.
. The related indicator
washing programme. Set this option
for very delicate fabrics. The rinse
phase uses more water for some
washing programmes
• Rinse Hold
. The related indicator
comes on.
The final spin is not performed. The
water of the last rinse is not drained
out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum.
The door stays locked and the drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
If you touch the Start/Pause
button, the appliance performs the
spinning phase and drains the water.
• Night
. The related indicator
comes on.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pause
button, the appliance performs only
the draining phase.
The appliance empties the
water out automatically after
approximately 18 hours.
8.5 Stain
Touch this button to add the stain phase
to a programme.
The corresponding indicator above the
touch button illuminates.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents