Agilent Technologies 969-9191 Instructions

87-900-835-01 (A)
May 25, 2006
The rack adapter shown in Fig. 1 is a 19" modular chassis system based on DIN
41494 part 5 manufactured by "Eurocard".
The modular chassis accepts standard 3U control units and provides mechanical
mounting in cases or racks corresponding to the dimensional requirements of 19"
front panels (DIN 41494 part 1).
The basic structure of this modular chassis system provides a further advantage. The
aluminum side panels are connected cross extrusions by four screws to give low-
weight strength and stability. This system reduces mounting times and cuts
mechanical systems down to a minimum.
Low chassis height provides easy mounting on chassis runners.
Telescopic slides may be fixed to standard mounting holes on the side panels.
Assemble the modular chassis as of Fig. 2 with the cross extrusion (3) so far enough
to support the control units to be installed.
1.
2.
3.
4.
6.
Varian Vacuum Technologies
121 Hartwell Avenue, Lexington, MA 02173, USA
INSTRUCTIONS
Rack Adapter 3 units
Model 969-9191
Fig. 1 - Rack adapter 3 units
Side panel
Cross extrusion, front
Cross extrusion, rear
Label strips
Exagon-head cap screw M4x12 with contact washer
Fig. 2 - Modular chassis assembly
NOTICE: This document contains references to Varian.
Please note that Varian, Inc. is now part of Agilent
Technologies. For more information, go to
www.agilent.com/chem.
Varian Vacuum Technologies
Varian S.p.A. - Via F.lli Varian, 54 - 10040 Leinì (TO) - Italy