Sharp PN-L862B Operation Manual page 52

Controlling the Monitor with a computer (RS-232C)
nResponse code format
When a command has been executed correctly
O K
A response is returned after a command is executed.
When a command has not been executed
E R R
TIPS
• "ERR" is returned when there is no relevant command or
when the command cannot be used in the current state of
the monitor.
• If communication has not been established for reasons
such as a bad connection between the computer and
monitor, nothing is returned (not even ERR).
• "ERR" may be returned when a command cannot be received
correctly due to interference from the surrounding environment.
Please ensure that the system or software resends the
command if this occurs.
If execution of the command is taking some time
W A I
When the following commands are used, "WAIT" is returned.
In this case, a value will be returned if you wait a while. Do not
send any command during this period.
• Commands which return "WAIT":
RSET, POWR, INPS, ASNC, BOMD, WIDE
52
E
Return code
(0D , 0A )
H H
Return code
(0D , 0A )
H H
T
Return code
(0D , 0A )
H H
nCommunication interval
• After "OK" or "ERR" is returned, you must send the
following commands.
To set a timeout for the command response, specify 10
seconds or longer.
• Provide an interval of 100 ms or more between the
command response and the transmission of the next
command.
VOLM0020
OK
Interval of 100 ms or more
INPS0001
WAIT
OK
TIPS
• When "ALL RESET" is executed, this monitor will restart.
Wait at least 1 minute before sending the next command.
• Before sending a power "On" or "Off" command, it is
recommended that you perform buffer clear at the sending
application side.
• After executing a power "On" or "Off" command, wait at
least 1 minute before sending the next command.