Window Air Conditioner Installation - Hisense AW-12DR3RYFU20 Use And Installation Instructions

Install Side Curtains
1. Place cabinet on the floor, a bench, or a table.
2. Slide "Ⅰ" section at the end of side curtain into side retainer on each side of the cabinet.
3. On each side of cabinet, insert the curtain housing into channel in the top and bottom angle rails.
Curtain housing
Place Cabinet in Window
1. Open the window and mark the center of window inner
sill as shown .
Cut the adhesive seal to the width of the lower window sash.
Remove the backing from the seal and attach the seal
to the bottom of the lower window sash.
A
A. Lower window sash
B. Adhesive seal
3. Shift cabinet left or right as needed to line up center
of cabinet on center line marked on inner sill.
For wooden window: Fasten cabinet to window inner
sill with two 3/4" long hex head screws into holes
(You may wish to pre-drill pilot holes).
5. Remove protective strip from adhesive side of
Bottom Rail Foam Seal Apply Seal over screws
fastening bottom rail to window inner sill.

Window Air Conditioner Installation

Side curtain
Side retainer
B
3 /4" long
HEX-HEAD
SCREW
2. Place cabinet in window with cabinet bracket
securely seated over the edge of inner sill as
shown in . Bring window down temporarily
behind top angle rail to hold cabinet in place.
window
inner sill
4. For Vinyl-Clad window: Place two safety locks
into the holes located in the bottom of the cabinet
and drive two 3/4" pan-head Phillips locking
screws through the safety locks into the cabinet
as shown.
A
B
A. 3/4" screws
B. Safety Lock (Only for Vinly-Clad Window)
C. Bottom Rail Foam Seal
7
Angle of cabinet
bracket securely seated
on edge of inner sill
.
cabinet
Bracket
window outer sill
C