Table of Contents
Advertisement
Turn on the water and check all hose connections for leaks. Make sure there are no kinks in
z
the hose(s). Check the hose connections for leaks again after 24 hours.
Uncoil power cord, remove and discard the plastic pin cover, and plug into wall socket.
z
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
z
Test cycle
Ensure the test cycle is completed before you dry any items in your dryer. The test cycle is to
check that your dryer is installed correctly and that it is functioning properly prior to use.
1
2
3
If there are any problems, you must address these before proceeding with normal use. The
dryer will automatically turn off at the end of the cycle if there are no problems.
COMPLETE INSTALLATION
Press
to activate your dryer.
POWER
Select the
cycle for 30 minutes.
TIME DRY
Ensure the drum is empty and the door
is closed (you will hear it click shut).
Press
, the drum will start rotating.
Observe the dryer for any problems.
The dryer will beep and display any faults on
the screen. If there are any problems, refer to
your user guide.
At the completion of the cycle, open
the door and check that there is warmth
inside the dryer. This indicates the dryer
is operating normally.
TO BE COMPLETED BY THE INSTALLER
…
Is the dryer correctly levelled, and are the cabinet corners clear of the floor
and walls?
…
Is the drain hose attached to the correct outlet and hooked into a standpipe or tub?
…
Has the water inlet been connected correctly?
…
Are the water tank, condenser filter, foam filter and lint filter correctly in place?
…
Has the power cord been connected to an appropriate power supply and the power
turned on?
…
Have you performed the test cycle?
9
Advertisement
Table of Contents
