Case Rear Assy - Sony NW-A100TPS Service Manual

NW-A100TPS/A105/A105HN/A106HN
Note: Follow the disassembly procedure in the numerical order given.
2-2.

CASE REAR ASSY

Note 1: When replacing the case rear assy of NW-A100TPS, it is
replace with the case rear assy for NW-A105 (Black).
Therefore, NW-A100TPS exclusive engravement is lost.
1 Attach the suction cup on the lower side of rear
case assy and pull it to raise the case rear assy.
Note 5: Use a commercial products of suction
1 Insert the jig into the gap between case rear
assy and cap bottom assy, and raise the
case rear assy.
Note 3: When using a jig, please work carefully
so as not to damage the case rear assy
and cap bottom assy.
Note 4: Refer to "JIG" on page 27 about tool
for disassembling.
2 Peel off the sheet adhesive case rear by hand
toward the top side gradually.
Note 6: Since the rear case assy is thin and it might
be break, so peel the sheet adhesive
case rear slowly and carefully.
guide line
(center)
guide
line
guide
line
Refer to page 37 for pasting
position of sheet adhesive
cap bottom A.
29
three sheet adhesive
case rear
top side
– –
guide line
three sheet
adhesive
case rear
guide line
sheet case
rear
Refer to page 37 for pasting
position of sheet adhesive
cap bottom B.
Note 2: When the case rear assy is replaced, serial number
engraved on the rear side is changed.
–
rear side
sheet adhesive
cap bottom A
jig
bottom
side
sheet case rear
cap bottom assy
Note 7: After pasting the case rear assy, press firmly
on the whole surface of case rear assy.
three sheet adhesive
case rear
sheet adhesive
cap bottom A
press
press
press
press
sheet case rear
5 case rear assy (See Note 1, 2)
Note 8: When installing the case rear assy,
align the two grooves and two ribs.
3 Lift up the case rear assy in
the direction of the arrow.
Sony CONFIDENTIAL
For Authorized Servicer
case rear assy
rear side
cap bottom assy
–
top side
case rear assy
sheet adhesive
cap bottom B
press
press
press
press
press
press
press
case rear assy
sheet adhesive
cap bottom B
rib
4 claw
groove
4 claw
groove
press
rib
SYS SET