What To Do If - Electrolux ESL 66010 User Manual

16 electrolux
Long periods of non-operation
Do these steps when you do not use the ap-
pliance for a long period:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Keep the door open to prevent unpleas-
ant smells.
4. Keep the inner side of the appliance
clean.
Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C.

What to do if...

The appliance does not start or stops during
operation.
If there is a fault, first try to find a solution to
the problem yourself. Refer to 'What to do
Fault code and malfunction
• intermittent audible signal,
• the digital display shows
The appliance does not fill with water
• intermittent audible signal,
• the digital display shows
The appliance will not drain
• intermittent audible signal,
• the digital display shows
The anti-flood device operates
The program does not start
After the check, switch on the appliance. The
program continues from the point of inter-
ruption. If the malfunction shows again, con-
tact your Customer Care Centre.
If the display shows a fault code, not descri-
bed in the chart, contact your Customer Care
Centre.
The manufacturer is not responsible for
damage because of frost.
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
Moving the machine
Do these steps to move the appliance:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the appliance and the hoses.
4. Do not tilt the appliance during transport.
if...'. If you cannot find a solution to the prob-
lem yourself, contact your dealer or the Cus-
tomer Care Centre.
Possible cause and solution
• The water tap is blocked or restricted with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The installation of the water inlet hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The installation of the water drain hose is not correct. The
hose can be kinked or squashed.
Make sure that the installation is correct.
• Close the water tap and contact your Customer Care Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected.
Plug-in appliance to the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the program immediately.
These data are necessary to help you quickly
and correctly:
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here: