GPX R1007 Instruction Manual

R1007
INSTRUCTION MANUAL

Warnings and Precautions

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR
MOISTURE.
This symbol, located on back or bottom of
the unit, is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be
of sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol, located on back or bottom
of the unit, is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION: TO PREVENT ELECTRIC
SHOCK, MATCH WIDE BLADE OF PLUG
TO WIDE SLOT, FULLY INSERT.
To reduce the risk of electric shock, do not
remove cover (or back). There are no user-
serviceable parts inside. Please refer any
servicing to qualified service personnel.
WARNING: Changes or modifications to
this unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
WARNING: Danger of explosion if the unit's
batteries are incorrectly installed. Replace
only with the same or equivalent battery.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc),
or rechargeable (ni-cad, ni-mh, etc) batteries.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
How to Use This Unit
Powering the Unit
The Unit is powered by 2 AAA-Sized Batteries, not included.
Simply slide the battery compartment lid in the direction of the
engraved arrow, to expose the battery compartment and load or
unload the unit with batteries. (Batteries not included)
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad,
ni-mh, etc) batteries.
Turning the Unit Off and On
Use the Volume dial to turn the unit off and on.
VOL
OFF
To Power the unit on, turn the volume up. The dial will click,
and the Power Indicator Light on the front of the unit will
illuminate red.
VOL
To Power the unit off, turn the volume down until the dial
clicks and the Power Indicator Light goes dark.
OFF
Press the RESET button to reset the unit to the lowest fre-
quency.
Carrying the Unit
The Unit has two features that allow it to be easily taken
anywhere.
The lanyard can be connected to the lanyard connection. The
unit can then be worn around your neck, or it can be tied to a
backpack or jacket.
The Belt Clip allows you to secure the unit onto your clothing.
Scanning FM Radio Frequencies
RESET
When the SCAN button is pressed, the unit will begin scan-
ning, starting at the lowest numbered FM frequency. The unit
SCAN
RESET
will scan to the first available FM Frequency. Press the SCAN
button again to continue scanning up the FM Frequency
SCAN