Advertisement
Using EXP-1 with Mustang™ III-IV-V
The EXP-1 expression pedal (P/N 2301050000) is compatible
with Fender® Mustang™ III-IV-V amplifiers and Mustang Floor.
♫
Mustang Floor users: EXP-1 functions differently with
this product. Please see page 14 for instructions on
using the EXP-1 with the Mustang Floor...
The EXP-1 operates in two modes, Volume behavior mode and
Expression behavior mode. You switch between modes by
pressing down hard on the toe end of the expression pedal.
Red and green LEDs on the EXP-1 indicate the current pedal
mode:
• Volume
behavior mode is used to control master volume
(or the expression pedal can be set to OFF in Volume mode).
•
Expression
behavior mode can be used to control most
effect and amp parameters on your Mustang amplifier. Some
common uses are to control the frequency parameter of a
Wah effect or the rate/time parameter of a modulation or
delay effect.
♫
Expression mode is also useful for experimenting with
those "mystery" parameters that you're not quite sure
what they do—you can adjust the parameter with your
foot and continue playing uninterrupted while listening
to the parameter changes!
Before you can use the EXP-1 you need to:
1.
Download and install the latest version of Fender® FUSE™
software and download the current Fender FUSE owner's
manual, both available free of charge at: fuse.fender.com.
♫
SYSTEM REQUIREMENTS: Fender FUSE software is com-
patible with PC computers running Windows 7, Vista, or
XP and with Mac computers with Intel® processors run-
ning OSX 10.5 (Leopard) or above.
2.
Update the Firmware on your Mustang III/IV/V amplifier.
See page 2 for simple step-by-step instructions.
3.
Calibrate the EXP-1 (see below).
4.
Configure EXP-1 Settings (see below).
12
2 .0
EXP-1 Pedal Calibration
The first time you connect the EXP-1 to your Mustang ampli-
fier, you should calibrate it so that the expression pedal range
of movement is synchronized with the parameter ranges.
Calibration takes only a few seconds:
To calibrate the EXP-1:
1.
Plug the EXP-1 pedal into the "4 BUTTON" FOOTSWITCH
jack on the back of your Mustang amplifier using the
included cable.
2.
Turn the amplifier OFF.
3.
Press and hold the UTIL button on the amplifier, then turn
the amplifier ON. Continue holding the UTIL button down
until it is no longer illuminated.
4.
The EXP-1 expression pedal has been calibrated!
♫
Repeat the calibration procedure each time you change
EXP-1 pedals or plug the EXP-1 into a different amplifier.
(continued on next page...)
f e n d e r . c o m
Advertisement
