Table of Contents
Advertisement
Steps
1. Place the system in an upright position, and slide the display panel on the slots of the display-assembly base.
2. Route the display-backlight, touch screen, and display cable through the slots on the display-assembly base.
3. Place the display-assembly base on a clean and flat surface with the display panel facing down.
4. Replace the four screws (M3x5) to secure the display panel to the middle frame and display-assembly base.
5. Remove the four jig screws from the display panel.
6. Replace the four screw (M3x5) to secure the display panel to the middle frame and display assembly base.
7. Route the display cable in the routing guides on the display-assembly base.
Next steps
1. Install the
system
board.
2. Install the
camera
assembly.
3. Install the speakers.
4. Install the
rear-I/O
bracket.
5. Install the
bottom
cover.
74
Removing and installing components
Advertisement
Table of Contents
