3-3.3. Stator; 3-3.4. Bracket (2) - Honda EZ3000CX Manual

3.3.3. STATOR
1) Put the stator in the engine.
3.3.4. BRACKET (2)
1) Put the bracket (2) over the rotor.
Pull out the stator wirings through the opening of
the bracket (2).
Be careful not to give cuts to wires when pulling
them out from the bracket (2).
2) Tap on the rear cover evenly with a plastic
hammer to press the rotor bearing into the
bracket (2).
3) Fix the rear cover with bolts.
Bolt (M6-155L) (4)
Tightening torque: 7.0 N•m
Tighten the bolts evenly and in turns.
4) Install the bracket (2) into the anti-vibration rubber.
Nut (M8) (2)
Tightening torque: 7.0 N•m
Bracket (2)
Bolt
34
Plastic hammer
Anti-vibration rubber
Nut