Vox Power Drawer Installation Manual

VOX® POWER DRAWER & EDGE BUILD UP
INSTALLATION GUIDE
TOOLS REQUIRED:
Ratchet
1/2" Socket
1/4" Socket / Wrench
5/16" Socket / Wrench
4mm Hex Key
Philips Screwdriver / Driver
With table upside down on a protective surface place
edge build up in place and secure using 5/16"-18 x 2
1/2" hex head bolt & washer. Repeat for all build ups.
For Power Drawers with typical plug in power cords,
mount starting link of power chain horizontally to
drawer using 6-32 x 3/8" pan head machine screws
and 6-32 nuts.
Customer Support: 1.800.668.9318
Email: mail@nienkamper.com
Web: www.nienkamper.com
HARDWARE:
1/4"-20 x 7/8"
Joiner Bolt
1/4"-20 x 7/8"
Joiner Bolt
SUGGESTED MINIMUM CREW:
APPROXIMATE INSTALL TIME:
6-32 Nut #8 x 1/2"
Pan Head
Wood Screw
6-32 x 3/8"
#8 x 5/8"
Pan Head
Pan Head
Mach. Screw Wood Screw
Attach slides by clipping slide into back of drawer and
securing with #8 x 1/2" black pan head, phillips drive
wood screws.
For Power Drawers with hardwire cabling, mount
starting link of power chain vertically to drawer using
6-32 x 3/8" pan head machine screws and 6-32 nuts.
2
30 Min
5/16"-18 X 2 1/2"
Hex bolt