Panasonic NN-K153WF Service Manual page 42

1. When mounting Primary latch switch,Secondary latch switch and
short switch to door hook assembly, mount the Primary latch
swith, the Secondary latch switch and the short switch to the door
hook assembly as shown in table.
NOTE:
No specific adjustment during installation of Primary latch
switch,Secondary latch switch and short switch to the door hook
is necessary.
2. When mounting the door hook assembly to the oven assembly,
adjust the door hook assembly by moving it in the direction of
arrow in the illustration so that the oven door will not have any
play in it. Check for play in the door by pulling the door assembly.
Make sure that the latch keys move smoothly after adjustment is
completed. Completely tighten the screws holding the door hook
assembly to the oven assembly.
3. Reconnect the short switch and check the coninuity of the
monitor circuit and all latch switches again by following the
components test procedures.
10.2. Measurement of microwave output
The output power of the magnetron can be determined by performing IEC standard test
procedures. However, due to the complexity of IEC test procedures, it is recommended to test
24