Advertisement
d. Verify that course file loaded correctly
i.
ii.
iii.
How to use the tablet
1. On the Operating Instructions Screen select the TUTORIAL button to watch the training video.
2. On the Operating Instructions Screen select the START button to view course yardages.
3. Optional: For courses with multiple courses or 9's, select the correct course/9 first (highlight in
green)
4. Select the desired number of holes to play: 9/18
5. Begin playing your round.
6. If you do not get within 25 yards of the green, the tablet will not auto advance to the next
hole.
a. If this happens just select the Previous or Next buttons to navigate to the correct hole.
7. When you are finished, press the "end round" button.
How to Remove and Replace the tablet
1. Unclip the front plastic screen protector on sides of tablet
2. Push back the rubber gasket around the tablet case edges.
3. Remove the tablet.
Tip: Be gentle when removing the tablet so that the charge cable doesn't get damaged.
4. Plug in the micro USB cable using the right orientation into the new tablet.
Tip: You may need to reach from inside the Tempo Walk to plug in the charger cable securely.
5. Slide the tablet into the case, with the charger side first.
6. Make sure that the tablet is charging (top right of screen)
Tip: The battery icon will have a lightning bolt in it or say 100%.
7. Secure the rubber gasket around the tablet case edges.
8. Replace the plastic screen protector. Tip: Start with the top left tab placement.
Troubleshooting the Tablet
Yardages are not accurate (Note: It can take up to 30 seconds for tablet to show accurate yardage)
1. Check to see if the GPS location icon is on, it looks like an upside-down teardrop (located on the
top right of the tablet screen).
a. If this is flashing, the tablet is trying to connect to the GPS satellites. Give it a moment.
b. If the icon is missing, you may need to reset the tablet so that it can function correctly
again.
Simply hold the power button down until the reset option pops up. Then press reset.
Black Screen
1. Check to see if the tablet is powered on by pressing the power button on the top left of the tablet.
a. If the screen lights up, swipe your finger up from the bottom of the screen to unlock the
tablet and use it as normal.
b. If this does not work, look to see if the tablet charge cable is still plugged in.
i.
ii.
Press Start button on Operating Instructions page
Select 9/18 holes
Verify course name is correct (top left)
Remove the tablet and make sure the cable is snug in the charge port.
Note: You may also want to plug the tablet into a wall outlet and charge it up to
19
Advertisement
