Level The Range; Final Installation Checklist; Operation Checklist - GE PB970BMBB Installation Instructions Manual

LEVEL THE RANGE

11
Install the oven shelves in the oven and
A
position the range where it will be installed.
B Check for levelness by
placing a spirit level or
a cup, partially filled
with water, on one of
the oven shelves. If
using a spirit level, take
two readings—with the
level placed diagonally first in one
direction and then the other.
C The front and rear leveling legs can be
adjusted from the bottom.
Leg
leveler
Raise
range
D Use an open-end or adjustable wrench
to adjust the leveling legs until the range
is level.
Installation Instructions
Spirit level
Lower
range
9
FINAL INSTALLATION
12
CHECKLIST
• Check to make sure the circuit breaker is
closed (RESET) or the circuit fuses are
replaced.
• Be sure power is in service to the building.
• Check to be sure that all packing materials
and tape have been removed. This will
include tape on metal panel under control
knobs (if applicable), adhesive tape, wire
ties, cardboard and protective plastic.
Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated.
• Check to make sure that the doors are
parallel to each other and that both operate
smoothly. If they do not, see the Owner's
Manual for proper replacement.
• Check to make sure that the rear leveling
leg is fully inserted into the Anti-Tip bracket
and that the bracket is securely installed.

OPERATION CHECKLIST

13
• Turn on one of the surface units to observe
that the element glows within 60 seconds.
Turn the unit off when glow is detected. If
the glow is not detected within the time
limit, recheck the range wiring connections.
If change is required, retest again. If no
change is required, have building wiring
checked for proper connections and voltage.
• Check to make sure the Clock (on models
so equipped) display is energized. If a series
of horizontal red lines appear in the display,
disconnect power immediately. Recheck the
range wiring connections. If change is
made to connections, retest again. If no
change is required, have building wiring
checked for proper connections and
voltage. It is recommended that the clock
be changed if the red lines appear.
• Be sure all range controls are in the OFF
position before leaving the range.