Remove an M.2 SSD
Place your console on a soft cloth spread over a flat surface. You can then remove the
M.2 SSD.
1
Follow steps 1 through 4 in "Install an M.2 SSD".
2
Remove the M.2 SSD from the expansion connector.
Remove the screws that are securing the M.2 SSD.
Slightly lift up the M.2 SSD, and then hold the edge and pull diagonally upward.
Fasten the screws back on the spacers.
3
Follow steps 6 and 7 in "Install an M.2 SSD".
10
When disposing of the wireless controller
The lithium-ion battery of the wireless controller is recyclable. When disposing of the
wireless controller, remove the battery and follow local regulations regarding disposing
of batteries.
Caution
• Remove the battery in a location out of the reach of small children to help prevent
accidental swallowing of small parts such as the screws.
• Be careful not to hurt your nails or fingers when removing the controller casing.
• For safety reasons, attach tape or a seal on the metal part of the battery before
disposing.
Notice
Other than when disposing of the wireless controller, never remove the screws and
never remove the battery from the wireless controller.
1
Disconnect the USB cable from the wireless controller.
2
Remove the cover on the front of the controller.
Cover
3
Using a tool such as a screwdriver, remove the L1 and R1 buttons.
R1 button
L1 button