Sony A7RIII ILCE-7RM3A Operating Instructions Manual page 91

SONY:
Reference Guide
Guide de reference
Guia de referenda
4-747-612-14(1)
IIIIII I IIII I I 1111111111111111
©2018 Sony Corporation Printed in Thail and
4747612140
IEEE802.11b/g/n
2400 MHz
<
60 mW e.i.r.p.
Bluetooth 2400 MHz
<
10 mW e.i.r.p.
NFC
13.56 MHz < 42 dBµA/m
(13,56MHz) (10m)
DSC-RX100MSA
IEEE802.11b/g/n 2400 MHz < 60 mW e.i.r.p.
NFC
ZV-1
13.S6 MHz < 42 dBµA/m
(13,56MHz) (10 m)
IEEE802.11b/g/n 2400 MHz < 60 mW e.i.r.p.
Bluetooth 2400 MHz < 10 mW e.i.r.p.
mm
Owner's Record
Record the model and serial number (which are
located on the product) in the space provided
below. Refer to these numbers whenever you call
your Sony dealer regarding this product.
Model No. _ _ _ _ _ _ _ _ _ _
Serial No. _ _ _ _ _ _ _ _ _ _
WARNING
To reduce fire or shock hazard, do not expose the
unit to rain or moisture.
IMPORTANT SAFETY
INSTRUCTIONS
-SAVE THESE
INSTRUCTIONS
DANGER
TO REDUCE THE RISK
OF FIRE OR ELECTRIC
SHOCK, CAREFULLY
FOLLOW THESE
INSTRUCTIONS
If the shape of the plug does not fit the power
outlet, use an attachment plug adaptor of the
proper configuration for the power outlet.
&CAUTION
Battery pack
If the battery pack is mishandled, the battery pack
can burst. cause a fire or even chemical burns.
Observe the following cautions.
• Do not disassemble.
• Do not crush and do not expose the battery
pack to any shock or force such as hammering,
dropping or stepping on it
• Do not short circuit and do not allow metal
objects to come into contact with the battery
terminals.
• Do not expose to high temperature above 60"C
(140"F) such as in direct sunlight or in a car
parked in the sun.
• Do not incinerate or dispose of in fire.
• Do not handle damaged or leaking lithium ion
batteries.
• Be sure to charge the battery pack using a
genuine Sony battery charger or a device that
can charge the battery pack.
• Keep the battery pack out of the reach of small
children.
• Keep the battery pack dry.
• Replace only with the same or equivalent type
recommended by Sony.
• Dispose of used battery packs promptly as
described in the instructions.
• Do not expose to extremely low temperatures
of-20'C (-4'F) or lower or extremely low
pressures of11.6 kPa or lower.
Use a nearby wall outlet (wall socket) when
using the AC Adaptor/Battery Charger. If any
malfunction occurs, disconnect the plug from the
wall outlet (wall socket) immediately to disconnect
from the power source.
If you use the product with a charge lamp, note
that the product is not disconnected from the
power source even when the lamp turns off.
The power cord (mains lead), if supplied, is
designed specifically for use with this equipment
only, and should not be used with other electrical
equipment.
Notice
If static electricity or electromagnetism causes
data transfer to discontinue midway (fail), restart
the application or disconnect and connect the
communication cable (USB, etc.) again.
This product has been tested and found compliant
with the limits set out in the EMC regulation for
using connection cables shorter than 3 meters
(9.8 feet) except LAN cable.
The electromagnetic fields at the specific
frequencies may influence the picture and sound
of this unit.
If this unit is subjected to intense extraneous
noise, it may restart.
Note on Use of Wireless Function
Use of the wireless function of the unit may
not be permitted, depending on the rules and
regulations of the country or region
Always observe the rules and regulations of the
country or region regarding use.*
When using this unit in an aircraft or a hospital,
follow the instructions from the airline company
or the hospital to avoid possible interference with
instruments or medical devices caused by radio
waves from this unit.
For Customers in the U.S.A. and
Canada
RECYCLING RECHARGEABLE BATTERIES
Rechargeable batteries are recyclable.
You can help preserve our environment by
returning your used rechargeable batteries to the
collection and recycling location nearest you.
For more information regarding recycling of
rechargeable batteries, visit
www.sony.com/electronics/eco/environmental-
management
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines. This equipment has very
low levels of RF energy that is deemed to comply
without testing of specific absorption rate (SAR).
The available scientific evidence does not show
that any health problems are associated with
using low power wireless devices. There is no
proof, however, that these low power wireless
devices are absolutely safe. Low power Wireless
devices emit low levels of radio frequency energy
(RF) in the microwave range while being used.
Whereas high levels of RF can produce health
effects (by heating tissue), exposure of low•level
RF that does not produce heating effects causes
no known adverse health effects. Many studies
of low·level RF exposures have not found any
biological effects. Some studies have suggested
that some biological effects might occur, but such
findings have not been confirmed by additional
research.
This equipment has been tested and found to
comply with ISED radiation exposure limits set
forth for an uncontrolled environment and meets
RSS-102 of the ISED radio frequency (RF) Exposure
rules.*
For Customers in the U.S.A.
This equipment must not be co·located or
operated in conjunction with any other antenna
or transmitter.*
CAUTION
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Note:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
For Customers in Canada
This device contains licence·exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada's licence·exempt RSS(s). Operation is
subject to the following two conditions :
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.*
CAN ICES-3 B/NMB -3 B
For Customers in Europe
Manufacturer: Sony Corporation
EU Importer/manufacturer's authorized
representative: Sony Europe 8.V., Da Vincilaan
7-D1, 1930 Zaventem, Belgium.
UK Importer/manufacturer's authorized
representative: Sony Europe B.V., The Heights,
Brooklands, Weybridge, Surrey KT13 0XW, United
Kingdom.
Eco·design information for the AC adaptor, if
supplied, is available at the following website:
https://www.compliance.sony.eu/
Hereby, Sony Corporation declares that this
equipment is in compliance Directive 2014/53/EU.
The full text of the EU declaration of conformity is
available at the following internet address:*
http://www.compliance.sony.eu
Disoosal of waste batteries and
electrical and electronic eauipment
(applicable in the European llnion
and other c0t1ntries with separate
collection svstemsl
This symbol on the product, the battery or on
the packaging indicates that the product and
the battery shall not be treated as household
waste. On certain batteries this symbol might
be used in combination with a chemical symbol.
The chemical symbol for lead (Pb) is added if
the battery contains more than 0.004% lead . By
ensuring that these products and batteries are
disposed of correctly, you will help to prevent
potentially negative consequences for the
environment and human health which could
be caused by inappropriate waste handling.
The recycling of the materials will help to
conserve natural resources. In case of products
that for safety, performance or data integrity
reasons require a permanent connection with
an incorporated battery, this battery should be
replaced by qualified service staff only. To ensure
that the battery and the electrical and electronic
equipment will be treated properly, hand over
these products at end·of·life to the appropriate
collection point for the recycling of electrical and
electronic equipment. For all other batteries,
please view the section on how to remove the
battery from the product safely. Hand the battery
over to the appropriate collection point for the
recycling of waste batteries. For more detailed
information about recycling of this product or
battery, please contact your local Civic Office, your
household waste disposal service or the shop
where you purchased the product or battery.
For Customers in Singapore*
Complies with
IMDA Standards
D800353
For Customers in Malaysia*
~
MC:MC:
CIDF15000002
* Excluding the non·wireless model "DSC ·RX100"