Table of Contents
Advertisement
5.
5a
Guide roller (SUPPLY) assembly/
5a
Note 5a
(W5a)
(W5b)
(W5a)
5b
Fig. 2-2-16
B
6.
Slide deck assembly/
(L6a)
(W6)
BSlide deck assembly
(L6b)
Note 6a
Fig. 2-2-17
2-9
5b
Rail assembly
(P5)
Note 5b
Note 5c
(W5a)
Note 5d
C
Main deck assembly
Note 6b
CMain deck
assembly
(L6c)
(L6d)
Note 5a:
When reassembling, insert the tip
of the guide roller with the coil
spring put on it into the hole on
the main deck. Tighten the guide
roller by about 6 turns so that the
height of the guide roller assem-
bly is 19 mm or so as shown in
the figure.
Note 5b:
Pay careful attention to the spring not to lose it.
Note 5c:
Pay careful attention to the engagement of the rail assembly's
arm ends because they easily come off the engagement.
Moreover, make sure that there is neither deformation nor
damage observed in them.
Note 5d:
When removing the rail assembly, check to see if the collar is
securely set in the arm groove.
Note 6a:
When removing the slide deck assembly, pay heed to the three
components of the following because they are apt to come off
after the slide deck assembly is removed.
8a
Tension lever assembly/
Brake control lever assembly
8c
For reassembling those components, refer to Fig. 2-2-19 on
page 2-10.
Note 6b:
When reassembling the slide deck assembly to the main deck
assembly, combine them with each other by the side grooves
and then slide the slide deck assembly by 1 mm or so.
1mm
Guide roller
(s) assembly
19mm
Slide lever assembly
8b
Advertisement
Table of Contents
