Dometic CFF12 Operating Manual page 22

Operation
A
NOTICE! Damage hazard
Place the cooler as shown (fig. 1, page 7). If you operate the cooler in
a different orientation it can be damaged.
2. Connect the cooler (see chapter "Connecting the cooler" on page 19).
A
NOTICE! Excessively low temperature hazard
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
3. Press the "ON/OFF" button (fig. 3 1, page 11) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 2, page 11).
✔ The display (fig. 3 4, page 11) switches on and shows the current temperature.
✔ The cooler starts cooling the interior.
I
NOTE
When operating from a battery, the display switches off automatically if
the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
1. Close the lid.
2. Press the latch (fig. 2, page 10) down, until it latches in place audibly.
I
NOTE
CFF35, CFF45: When latching the lid, ensure that both latch side pins
are fully engaged to ensure a good lid seal. One latch may engage
slightly before the other.
If the lid is not closed equally at both sides, press until a second click is
heard.
6.6 Fixing the cooler while transporting (CFF12)
When transporting the cooler in a vehicle, you can fix the device with the safety seat
belt or with luggage tighteners so that it remains in its position.
!
WARNING!
Make sure that the cooler is fixed correctly. Otherwise it could be dis-
lodged and cause severe injuries to passengers when a hard break
occurs.
22
CFF12, CFF20, CFF35, CFF45, CFF70DZ
EN